|
|
| (8 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| The following menu commands are available in the [[SMS:BOUSS-2D|BOUSS-2D]] Menu:
| | #REDIRECT [[SMS:BOUSS-2D Graphical Interface]] |
|
| |
| {|border="1"
| |
| ! Command!! Functionality
| |
| |-
| |
| | [[SMS:Spectral Energy|Spectral Energy]]
| |
| |
| |
| Brings up the spectral energy dialog to define/view wave energy spectra. Generally, BOUSS-2D will generate wave conditions internally, but a spectrum may be input. This command also allows the user to visualize wave spectra that are generated inside of the model.
| |
| |-
| |
| | [[SMS:BOUSS-2D_BC_Cell_Strings|Assign BC]]
| |
| |
| |
| This command is used to assign damping, porosity, or wave maker conditions along a selected [[SMS:BOUSS-2D_BC_Cell_Strings|cell string(s)]].
| |
| |-
| |
| | Assign Cell Attributes
| |
| |
| |
| Selected cells can be defined as land or water
| |
| |-
| |
| | [[SMS:BOUSSS-2D Probes|Probe Manager]]
| |
| |
| |
| Brings up the Probe Manager to control time series output from the model
| |
| |-
| |
| | [[SMS:BOUSS-2D Calculators|Calculators]]
| |
| |
| |
| Brings up a pop up menu to access the Wave Conditions Calculator (see appendix A) as well as the Run-up/Overtopping Estimator.
| |
| |-
| |
| | Model Check …
| |
| |
| |
| Under development - check for common problems.
| |
| |-
| |
| | Model Control…
| |
| |
| |
| Brings up the Model Control dialog to specificy model parameters.
| |
| |-
| |
| | Run BOUSS-2D
| |
| |
| |
| Brings up a dialog that allows the user to check what executable of BOUSS-2D should be run and then runs the model with the currently loaded simulation. As the model runs, a dialog monitors progress of the model and gives the user status messages. When the run is complete, the spatial solutions are read in for analysis and visualization.
| |
| |}
| |
| | |
| | |
| {{Template:Navbox SMS Menus}}
| |
| {{Template:Navbox SMS}}
| |
| | |
| [[Category:SMS Menus|B]]
| |
| [[Category:BOUSS-2D|B]]
| |
