Fill Nodata Tool: Difference between revisions

From XMS Wiki
Jump to navigationJump to search
No edit summary
No edit summary
 
(One intermediate revision by the same user not shown)
Line 3: Line 3:
{{Navbox SMS}}
{{Navbox SMS}}


[[Category:Toolbox]]
[[Category:Toolbox Rasters]]

Latest revision as of 19:04, 26 October 2023


Fill Nodata

The Fill Nodata tool creates a new raster by filling in small areas or gaps in a raster where no elevation data exists. The command will interpolate an elevation to raster cells that are classified as "NODATA". The elevation for a NODATA cell is determined by interpolation based on the search radius specified. The command is intended to correct single isolated raster points or a single row/column, and is not intended to create data for large regions of NODATA cells, especially regions on the border of the raster.

Input parameters

  • Input raster – The source raster containing the NODATA values.
  • Maximum distance (in pixels) to interpolate – Enter a distance used to search out values to interpolate from, to fill in the NODATA values. The default is 100 pixels.
  • The number of 3x3 average filter smoothing iterations to run – Enter the number of smoothing iterations to run after the interpolation has been calculated. The default is 0 runs.

Output parameters

  • Output raster – Enter a name for the new raster.

Current Location in toolbox

  • Rasters/Fill Nodata