The Smooth Dataset tool is used to condition scattered data scalar values before those values are used in an interpolation process. This includes two general applications, smoothing a size dataset to prevent the dataset values from changing too quickly, and smoothing depth/elevation values to prevent extreme slopes.
Smoothing Size Datasets
One measure of mesh quality is element area change. If the dataset values change too quickly in a size dataset, the element area change of adjacent elements may be too great, resulting in poor mesh quality.
- Element area change limit – The selected dataset values will be modified to honor the specified element area change limit. This value defines the maximum ratio between adjacent points based on the distance between points.
- Minimum value anchor type – Dataset values are decreased. Results in a more refined (more nodes/elements) mesh when used as a size dataset.
- Maximum value anchor type – Dataset values are increased. Results in a less refined (fewer nodes/elements) mesh when used as a size dataset.
- Minimum node spacing – The minimum value allowed in the smoothed dataset.
After smoothing a size dataset, use the data calculator to subtract the smoothed sized dataset from the original dataset and create a "change" dataset. Contour the "change" dataset to easily determine what and where changes were made by the smoothing algorithm.
Smoothing Elevation/Depth Datasets
This option allows specifying a maximum slope. The process creates a new dataset which honors the maximum specified slope.
- Minimum value anchor type – The smoothing operation anchors the minimum dataset value (such as the lowest elevation or smallest depth) and adjusts the adjacent values to ensure the slope is less than or equal to the specified slope.
- Maximum value anchor type – The smoothing operation anchors the maximum dataset value (such as the highest elevation or largest depth) and adjusts the adjacent values to ensure the slope is less than or equal to the specified slope.
The operation includes all scatter points if none are selected. Alternatively, select a group of scatter points to be operated on. Points not selected will not have their scalar value modified. This means the only way to modify a point is if it has an adjacent point that is also selected and the slope between these two selected vertices is steeper than the maximum specified slope.
SMS – Surface-water Modeling System
|1D Grid • Cartesian Grid • Curvilinear Grid • GIS • Map • Mesh • Particle • Quadtree • Raster • Scatter • UGrid
|3D Structure • FVCOM • Generic • PTM
|ADCIRC • BOUSS-2D • CGWAVE • CMS-Flow • CMS-Wave • GenCade • STWAVE • WAM
|AdH • HEC-RAS • HYDRO AS-2D • RMA2 • RMA4 • SRH-2D • TUFLOW • TUFLOW FV
|Aquaveo • SMS Tutorials • SMS Workflows