SMS:SRH-2D Culvert Workflow

From XMS Wiki
Revision as of 20:27, 12 August 2015 by Jcreer (talk | contribs)
Jump to navigationJump to search

To build an SRH-2D model using a culvert, use the following steps:

2. Create culvert boundary conditions.
  1. Create boundary condition arcs for the culvert.
  2. Specify the HY-8 culvert definition file.
  3. Assign the boundary condition attributes and define the culvert in HY-8.
  4. Modify the materials coverage.
3. Specify the initial conditions of the stream.
4. SRH-2D simulation setup.
  1. Create new simulation.
  2. Add components to simulation.
  3. Set up Model Control parameters.
  4. Check the model.
  5. Simulation execution.
  6. Troubleshooting.
5. Review results.
  1. Open _XMDF file.
  2. Results layers.
  3. Observation lines.
  4. Summary table.
  5. Run the Plot Wizard.
  6. Data calculator.