ADCIRC Levee Checks Workflow: Difference between revisions

From XMS Wiki
Jump to navigationJump to search
(Created page with "To use the ADCIRC levee checks with the an ADCIRC Project, use the following steps: {{ADCIRC Levee Checks Workflow}} {{Navbox SMS}} ADCIRC")
 
m (Protected "ADCIRC Levee Checks Workflow" ([Edit=Allow only administrators] (indefinite) [Move=Allow only administrators] (indefinite)))
 
(One intermediate revision by the same user not shown)
Line 1: Line 1:
To use the [[SMS:ADCIRC|ADCIRC]] levee checks with the an ADCIRC Project, use the following steps:
The ADCIRC check tools, check and lower, if needed, the elevations of an ADCIRC domain based on the crest elevations defined in an ADCIRC Boundary Conditions coverage. The ADCIRC To use the [[SMS:ADCIRC|ADCIRC]] levee checks with the an ADCIRC Project, use the following steps:


{{ADCIRC Levee Checks Workflow}}
{{ADCIRC Levee Checks Workflow}}

Latest revision as of 20:47, 18 April 2023

The ADCIRC check tools, check and lower, if needed, the elevations of an ADCIRC domain based on the crest elevations defined in an ADCIRC Boundary Conditions coverage. The ADCIRC To use the ADCIRC levee checks with the an ADCIRC Project, use the following steps:

The ADCRIC check/fix levee tools require an ADCRIC project with the following components:

  • An ADCRIC boundary conditions converage.
  • A 2D mesh or grid used as the domain for the ADCIRC simulation.
1. Check/fix levee crest elevations.
  1. Click the Toolbox Toolbox macro.png macro to open the Toolbox dialog.
  2. In the Toolbox dialog, select the Check/Fix Levee Crest Elevations tool under the ADCRIC folder and click the Run Tool... button.
  3. In the ADCIRC Check/Fix Levee Crest Elevations dialog, select the ADCRIC boundary conditions coverage and the domain grid, then enter the other parameters before running the tool.
2. Check/fix levee ground elevations.
  1. Click the Toolbox Toolbox macro.png macro to open the Toolbox dialog.
  2. In the Toolbox dialog, select the Check/Fix Levee Ground Elevations tool under the ADCRIC folder and click the Run Tool... button.
  3. In the ADCIRC Check/Fix Levee Ground Elevations dialog, select the ADCRIC boundary conditions coverage and the domain grid, then enter the other parameters before running the tool.