GMS:Horizons Applications: Difference between revisions

From XMS Wiki
Jump to navigationJump to search
No edit summary
 
Line 20: Line 20:
In this application the user wanted to create a set of solids where there would be distinct materials below a river bed compared to the other materials in the study area. The following cross section shows what the user wanted to create.
In this application the user wanted to create a set of solids where there would be distinct materials below a river bed compared to the other materials in the study area. The following cross section shows what the user wanted to create.


[[Image:Xsect_hor_application.png|border]]
[[Image:Xsect_hor_application.png|400px|border]]


=== Primary TINs ===
=== Primary TINs ===

Revision as of 17:47, 23 June 2011

The horizons method has been applied at a variety of sites to construct solid models of the subsurface. This page highlights example applications of the Horizons Method.

Modeling a Slope Failure

In this example a combination of boreholes, user defined cross sections, and TINs were used to create solids at a site with a slope failure.

Borehole data
Surface elevations
Failure surface
User defined cross sections
One user cross section
Zoomed in on cross sections
Solids created from user data
Cross sections from solids
Zoomed in on cross sections

Vertical Boundary Between Solids

In this application the user wanted to create a set of solids where there would be distinct materials below a river bed compared to the other materials in the study area. The following cross section shows what the user wanted to create.

Xsect hor application.png

Primary TINs

To create solids that would match this cross section, the user created 2 different primary tins and executed the Horizons->Solids command for each primary TIN. The first TIN covered the area of the river and the second TIN covered the remainder of the study area as show in the images below.

Tin1.png Tin2.png

Solids

The user had TINs that defined the top elevations of the horizon surfaces. There were 3 TINs used in the area around the river and there were 4 TINs used the remainder of the study area. Solids were created for the river area using the first TIN as the primary TIN. Solids were also created in remainder of the study area by using the second TIN as the primary TIN. Notice the the bottom most material matches in both sets of solids. This is because the same TIN with that horizon was used when creating both sets of solids.

Solids river.png Solids StudyArea.png

Cross Sections from Solids

These images show the solids together and cross section cut through the solids. Again notice how the bottom most material matches across both sets of solids.

AllSolids.png AllSolids XsectXY.png
AllSolids Xsect.png