HY8:Channel Shape
From XMS Wiki
Jump to navigationJump to search
There are three available channel shapes to define the downstream tailwater channel: rectangular, trapezoidal, and triangular. When selecting a channel shape the input window adjusts to display only those parameters required for the defined shape. When defining a channel shape, the following channel properties are required for analysis:
- Bottom Width — Width of channel at downstream section, shown in drawing below.
- Side Slope (H:V) (_:1) — This item applies only for trapezoidal and triangular channels. The user defines the ratio of Horizontal/Vertical by entering the number of horizontal units for one unit of vertical change.
- Channel Slope — Slope of channel in m/m or ft/ft. If a zero slope is entered, an error message appears upon exiting the input data window. The user must enter a slope greater than zero before the crossing may be analyzed.
- Manning's n — User defined MANNING'S roughness coefficient for the channel.
- Channel Invert Elevation — User must enter elevation. Program will show actual barrel #1 outlet invert elevation.
