SMS:SRH-2D Culvert Workflow: Difference between revisions

From XMS Wiki
Jump to navigationJump to search
No edit summary
No edit summary
Line 14: Line 14:
|width="800"|
|width="800"|
:#Create a [[SMS:SRH Coverages#Boundary Conditions Coverage|boundary conditions]] coverage.
:#Create a [[SMS:SRH Coverages#Boundary Conditions Coverage|boundary conditions]] coverage.
:#Create boundary condition arcs for the culvert.  
:#Create boundary condition [[SMS:Create Arcs|arcs]] for the culvert.  
:#Specify the HY-8 culvert definition file.
:#Specify the HY-8 culvert definition file.
:#Assign the boundary condition attributes and define the culvert in HY-8.
:#Assign the boundary condition attributes and define the culvert in HY-8.

Revision as of 21:45, 12 August 2015

To build an SRH-2D model using a culvert, use the following steps:

2. Create culvert boundary conditions.
  1. Create a boundary conditions coverage.
  2. Create boundary condition arcs for the culvert.
  3. Specify the HY-8 culvert definition file.
  4. Assign the boundary condition attributes and define the culvert in HY-8.
  5. Modify the materials coverage.
3. Specify the initial conditions of the stream.
4. SRH-2D simulation setup.
  1. Create new simulation.
  2. Add components to simulation.
  3. Set up Model Control parameters.
  4. Check the model.
  5. Simulation execution.
  6. Troubleshooting.
5. Review results.
  1. Open _XMDF file.
  2. Results layers.
  3. Observation lines.
  4. Summary table.
  5. Run the Plot Wizard.
  6. Data calculator.