SMS:SRH-2D Pressure Flow Bridge Workflow: Difference between revisions

From XMS Wiki
Jump to navigationJump to search
No edit summary
No edit summary
Line 34: Line 34:
|-
|-
|width="800"|
|width="800"|
:# [[SMS:File Menu|Save]] the project.
{{SMS:SRH Run Simulation Workflow}}
:# [[SMS:Model Checker|Check the model]].
:# [[SMS:SRH Simulation#Running an SRH-2D Simulation|Simulation execution]].
:# [[SMS:SRH-2D#Troubleshooting|Troubleshooting]].
:See also: [[SMS:SRH Simulation Workflow|SRH Simulation Workflow]]
|}
|}
{|class="wikitable collapsible autocollapse"
{|class="wikitable collapsible autocollapse"

Revision as of 18:20, 18 August 2015

To build an SRH-2D model using a pressure flow bridge, use the following steps:

2. Create pressure flow boundary conditions.
The pressure flow boundary conditions must be defined before running the simulation. To do this:
  1. Create a boundary conditions coverage.
  2. Create boundary condition arcs for the pressure flow.
  3. Assign boundary condition attributes to the pressure flow arcs.
3. Specify the simulation parameters.
The simulation parameters must be defined before running SRH-2D. To do this:
  1. Create new simulation.
  2. Add components to simulation.
  3. Set up the simulation Model Control parameters.
See also: SRH Simulation Workflow
4. Run the SRH-2D simulation.

SMS:SRH Run Simulation Workflow

5. Review results.
Results for the pressure flow can be visualized by doing the following:
  1. Create observation arcs.
  2. Run the Plot Wizard.