A well pumping rate can be used to calibrate a MODFLOW model. This requires create well with actual pumping rate (negative for extraction). To calibrate an existing MODFLOW model using the well pumping rate, use the following steps:
Expand1. Define MODFLOW parameters.
|
- Define the MODFLOW parameters using the well and the pumping rate assigned to the well.
- Select MODFLOW | Parameters to open the Parameters dialog.
- Click the New button.
- Turn on Show all columns checkbox.
- Change the Type column to "WELL".
- In the Key column, enter actual pumping rate.
- Enter inverse of pumping rate value in the Value column.
- Enter Min and Max values greater than 0. These and “Value” will be multiplied by the Q factor later which will be negative 1, so positive values here will actually be negative.
- Turn on Log Xform
|
Expand2. Define well options.
|
- Select MODFLOW | Optional Packages | WEL - Well' to open the MODFLOW Well Package dialog.
- For the Q factor column, enter "-1.0".
|