HY8:Roadway Data: Difference between revisions

From XMS Wiki
Jump to navigationJump to search
No edit summary
No edit summary
 
(4 intermediate revisions by one other user not shown)
Line 1: Line 1:
When defining the roadway data for the culvert, the following parameters are required:
When defining the roadway data for the culvert, the following parameters are required:


* [[HY-8:Roadway Profile|Roadway Profile]]
* [[HY8:Roadway Profile|Roadway Profile]]
*Roadway Station
*Roadway Station
*Crest Length  
*Crest Length  
Line 8: Line 8:
*Top Width
*Top Width


The roadway elevation can be either a constant or vary with station.  An initial roadway station may be defined or left at the default of 0.0.  The stationing is used to position culverts along the length of the roadway profile when choosing the ''Front View'' option. 


The roadway elevation can be either a constant or vary with station.  An initial roadway station may be defined by the user or left at the default of 0.0.  The stationing is used to position culverts along the length of the roadway profile when choosing the ''Front View'' option. 
The roadway surface may be paved or gravel or an overtopping discharge coefficient in the weir equation may be entered.  As the overtopping flow will cross the roadway surface, median, and shoulders, this discharge coefficient should take all of these materials into account.  Select a paved roadway surface or a gravel roadway surface from which the program uses a default weir coefficient value.  If input discharge coefficient is selected, enter a discharge coefficient between 2.5 and 3.095.   
 
 
The roadway surface may be paved or gravel, or an overtopping discharge coefficient in the weir equation may be entered.  The user may select a paved roadway surface or a gravel roadway surface from which the program uses a default weir coefficient value.  If input discharge coefficient is selected, the user will enter a discharge coefficient between 2.5 and 3.095.   
 
   
   
The values entered for the crest length and top width of the roadway have no effect on the hydraulic computations unless overtopping occurs.
The values entered for the crest length and top width of the roadway have no effect on the hydraulic computations unless overtopping occurs.
Line 19: Line 16:


{{HY8Main}}
{{HY8Main}}
[[Category:Crossing Data|R]]

Latest revision as of 20:38, 28 February 2018

When defining the roadway data for the culvert, the following parameters are required:

  • Roadway Profile
  • Roadway Station
  • Crest Length
  • Crest Elevation
  • Roadway Surface
  • Top Width

The roadway elevation can be either a constant or vary with station. An initial roadway station may be defined or left at the default of 0.0. The stationing is used to position culverts along the length of the roadway profile when choosing the Front View option.

The roadway surface may be paved or gravel or an overtopping discharge coefficient in the weir equation may be entered. As the overtopping flow will cross the roadway surface, median, and shoulders, this discharge coefficient should take all of these materials into account. Select a paved roadway surface or a gravel roadway surface from which the program uses a default weir coefficient value. If input discharge coefficient is selected, enter a discharge coefficient between 2.5 and 3.095.

The values entered for the crest length and top width of the roadway have no effect on the hydraulic computations unless overtopping occurs.