WMS:MWBM Locations

From XMS Wiki
Revision as of 20:08, 14 November 2014 by Jcreer (talk | contribs)
Jump to navigationJump to search
MWBM Modeling Wizard showing the Pumping Locations step

The Pumping Locations step is used to specify the locations of pumps.

Help

Add Pumping Locations – This button turns on the tool to create a node with a GSSHA pumping attributes. If there is a default curve selected, the newly created pumping location will use that curve.

Delete Pumping Locations – This button turns on the tool to delete nodes.

Pumping Curves – This button launches the curve editor to add a new pumping curve to the list of curves available to select as the default curve, or to select in the spreadsheet in the shown locations.

Pumping Locations Spreadsheet – The spreadsheet shows existing output locations by Cell numbers and allows the user to define the pumping curve to be used at that location.


MWBM Modeling Wizard showing the Output Locations step

The Output Locations step is used to specify the location where GSSHA will generate a hydrograph.

Help

Add Output Locations – This button turns on the tool to create a node with a GSSHA Hydrograph output attributes. Note that you must click on an existing point.

Delete Output Locations – This button turns on the tool to delete the Hydrograph Output from a selected node.

Output Locations Spreadsheet – The spreadsheet shows existing output locations by Link Numbers and Node Numbers.