|
|
Line 26: |
Line 26: |
| | | | | |
| <blockquote> | | <blockquote> |
| | | {{MODFLOW Calibration Parameters Workflow}} |
| </blockquote> | | </blockquote> |
| |} | | |} |
Revision as of 20:05, 13 March 2017
To calibrate an existing MODFLOW model, use the following steps:
1. Create observation data.
|
1. Create an observation coverage.
|
- Create a coverage with at least one Observation Points option turned on.
1. Create new coverage from scratch.
|
- Use the New Coverage right-click command.
- Use the Coverage Setup dialog to create a new coverage by selecting the desired coverage properties and naming the coverage.
|
2. Create new coverage from an existing coverage.
|
- Use the Duplicate command on an existing coverage. This will copy any feature objects on the coverage.
- Use the Rename command to give the coverage a new name.
- Change the coverage setup.
|
|
2. Create observation points or arcs.
|
1. Create feature points, arcs, nodes and vertices.
|
- In the map module, create feature objects in the active coverage.
- Use the Create Arc tool to create arcs in the map coverage.
- Begin creating a new arc by clicking in the graphics window at either arc end. If clicking on an existing feature node, vertex or arc, the new arc will snap to that object.
- Double-click or press the Enter key to terminate the arc.
- Use the Create Point tool to create additional nodes alone or to split arcs.
|
2. Modify arcs.
|
- Feature arcs, whether digitized or incorporated from a boundary condition or a material coverage, often need to be edited after initial creation.
1. Create additional vertices on arcs.
|
- Use the Create Vertex tool to add vertices along arcs.
|
3. Split arcs.
|
- An existing arc can be split by:
2. Add a node to the arc.
|
- Use the Create Point tool to add a node on an arc in order to split it into two arcs.
|
3. Connect the end of an existing arc to the middle of the arc.
|
- Use the Select Points\Nodes tool to drag the node of an existing arc to anywhere in the middle of another arc. This will split the second arc into two arcs.
|
4. Add a new connecting arc.
|
- Use the Create Arc tool to start or end a new arc on an existing arc to split the existing arc into two arcs.
|
|
|
|
3. Set observation point or arc attributes.
|
- With the Select Point/Node tool, right-click on the observation point and select the Attribute Table command.
- Set the observation attributes in the Attributes Table dialog.
- With the Select Arc tool, right-click on the observation arc and select the Attribute Table command.
- Set the observation attributes in the Attributes Table dialog.
|
|
2. View observation data.
|
- Create a plot of the observed data by doing the following:
2. Select available plot type.
|
1. Computed vs. Observed Data plots.
|
|
2. Residual vs. Observed Data plots.
|
|
|
|
3. Change parameters.
|
1. Change model parameters.
|
- Model parameters are usually adjusted in the Map model on the appropriate coverage—usually the coverage with recharge or hydraulic conductivity values.
- With the Select Arc , Select Point/Node , or Select Polygon tool, right-click on the desired feature object and select the Attribute Table command.
- Adjust the attributes in the Attributes Table dialog to calibrate the model.
|
|