GMS:MODFLOW Grid Approach

From XMS Wiki
(Redirected from GMS:Build MODFLOW 3D Grid)
Jump to navigationJump to search
MODFLOW
Pre-processing
MODFLOW Commands
Building a MODFLOW Model
Map to MODFLOW
Calibration
Packages Supported in GMS
Saving a MODFLOW Simulation
Importing MODFLOW Files
Unsupported MODFLOW Features
Run MODFLOW
Post-processing
MODFLOW Display Options
MODFLOW Post-Processing Viewing Options
Reading a MODFLOW Simulation
Tutorials
Packages
Flow: BCF6, HUF, LPF, UPW
Solvers:

DE4, GMG, NWT, PCG,

PCGN, LMG, SIP, SOR,

SMS
Other:

BAS6, BFH, CHD1, CLN,

DRN1, DRT1, EVT1, ETS1,

GAGE, GHB1, GNC, HFB1,

HUF, LAK3, MNW1, MNW2,

OUT1, RCH1, RIV1, SFR2,

STR1, SUB1, SWI2, WEL1,

UZF1

Building a MODFLOW 3D Grid

For models with simple geometry and boundary conditions, the entire model can be constructed using the tools and commands in the 3D Grid module. With this approach, the editing of the MODFLOW data is performed directly on the grid on a cell-by-cell basis. The main steps are as follows:

  1. Create a 3D cell-centered grid covering the domain to be modeled using the Create Grid command in the Grid menu.
  2. Use the commands in the MODFLOW menu to initialize and define the data required by the MODFLOW packages.
  3. Boundary conditions such as wells are defined by selecting the cells and assigning the attributes directly to the cells.

Defining the Layer Data

An important part of a MODFLOW model is the definition of the layer data (hydraulic conductivity, layer elevations, leakance, etc.). While both the Grid and Map module approaches to constructing a MODFLOW model can be used to define the layer data, both approaches may lead to an overly simplistic definition of the stratigraphy. Layers with spatially varying thicknesses can be handled most effectively using a special set of layer data tools provided in GMS. Solids can also be used to define layer data with the Solids→MODFLOW and Solids→HUF commands.